![]() 4 hours after applying the last waterproofing layer. 90 minutes, and the horizontal surfaces, floors, become practical and can be cladded with ceramic tiles after approx. On vertical surfaces, walls, ceramic tiles can be executed after approx. To ensure non-stress drying, the amount per coat should not exceed 1.5 kg / m2. The next layer can be applied when the first layer can no longer be damaged by applying the new layer. The minimum layer must be observed at every point of the waterproofing surface. The first coat of superflex D2 weber.tec is applied to a properly prepared, compact coat over the entire surface (consumption approx. For obtaining a waterproofing layer, it is necessary to apply at least two layers (3 layers for surfaces exposed to water under pressure). The obtained paste can be applied with a wall paint brush or roller, notched trowel or automatized. Pour the fluid into a bucket, add the powdered component, then mix it (2 -3 minute) with an electric mixer (maximum speed of 800 rpm) until a homogeneous paste is obtained, without agglomerations. Cracks and cavities larger than 5 mm must be closed, filles.įlexible weber.tec superflex D2 waterproofing is a two-component material: a fluid-paste component and a powdery one. The edges and corners must be rounded and the protruding parts flattened. Remove waterproofing parts and debris that may reduce adhesion. The underlay must be clean, non-deformable, dry, fixed and free of anti-adhering substances (grease, bitumen, tar, dust etc.), frost free, no large cracks or protruding parts. Recommended especially for waterproofing under ceramic tiles. Also as an adhesive for extruded polystyrene sheets, rigid foam boards and mineral fiber tiles. As preliminary waterproofing and bonding layer under polymer modified bituminous layer, waterproofing continues under masonry, bonding layer on old surfaces of anionic bitumen. For waterproofing water tanks (inside, up to 15 m water column). Also for subsequent waterproofing of the interior basement walls. The application is possible with a masonry brush, brush, trowel, as well as a spraying aggregate.For flexible external waterproofing of basement walls made from masonry or concrete, below ground level, concrete floors or foundations. bonding layer on existing bituminous (asphalt) coatings.pre-sealing and adhesive layer for sealing of polymer-bituminous mastics (KMB).sealing wet and damp rooms (bathrooms, showers).sealing composite (sub-tile) balcony and terrace in.sealing water tank, including drinking water up to 15 m water column, as well as swimming pool, tank in sewage treatment plant.secondary insulation of buildings and structures (walls, floors), also bath type.sealing with negative water pressure (removing the waterproofing from the ground) - cavity up to 3 m below the groundwater table.foundation benches, foundation walls, foundation slabs) execution of horizontal and vertical waterproofing embedded in the ground of parts of buildings and structures (e.g.drying independent of atmospheric conditions (chemical bond).traffic load and the ability to cover tiles after 4 hours.tank filling in: after 3 days (at +23 C and 50% relative humidity) application (air and substrate) temperature from +3 C to +30 C.processing time ~ 45 min (at +23 C and 50% relative humidity).density of ready-mixed mortar ~ 1.05 kg / dm 3.setting and hardening - hydraulic and as a result of chemical reaction.the number of applied layers is a minimum of 2.the possibility of further processing after 90 min. ![]() based on cement, selected aggregate, special polymer in.It binds without scratches or internal stress. Weber.tec Superflex D2 is a flexible, fast-setting sealing micro-mortar.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |